Xerox 5222 ошибка 077 106

Вернуться в Принтеры, МФУ, копиры формата A3

Кто сейчас на форуме

Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 31

BSD-ON:

BSD 4.1 — Main Drive Control

BSD-ON:

BSD 10.2 — Fusing

The Fuser Exit Sensor does not turn ON within the specified time after the Registration Clutch

On.

NOTE: When turning the power OFF, turn OFF the power switch first and then the main power

switch.

Procedure

Check the following:

•

The Fuser Exit Sensor for failure:

Component Control

•

A paper transportation failure due to a foreign substance/burr on the paper path

•

The Fuser Exit Sensor for contamination, improper installation, and Actuator operation

failure

•

Each Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure

•

The Registration Roll and Pinch Roll for contamination, wear, and revolution failure

•

The BTR for contamination, wear, and revolution failure

•

The Fuser for wound up, stuck paper

•

The Fuser Drive Gear for wear and damage

•

Use of paper out of spec

Reload the machine software

(GP

16). If no problems are found, replace the MCU PWB

18.2).

Status Indicator RAPs

077-106, 077-109

077-109 Exit Sensor 2 On Jam RAP

BSD-ON:

BSD-ON:

After the Fuser Exit Sensor turned ON, the Exit 2 Sensor did not turn ON within the specified

time.

NOTE: When turning the power OFF, turn OFF the power switch first and then the main power

switch.

Initial Actions

Check the following:

[077-101]

(PL

7.1)

•

•

•

•

•

•

•

Procedure

Check the following:

(PL

•

•

•

•

Reload the machine software

18.2).

07/2011

2-804

BUS Updated 12/2011

BSD 10.3 — Exit Transportation

BSD 10.4 — Exit 2 Drive

A paper transportation failure due to a foreign substance/burr on the paper path

Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure

The Fuser for wound up, stuck paper

Each Exit Roll Drive Gear for wear and damage

The Exit 1 Gate for operation failure

Use of paper out of spec

The Exit 2 Sensor for contamination, improper installation, and Actuator operation failure

The Exit 2 Sensor for failure:

Component Control

The connection between the Exit 2 Sensor

circuit, short circuit, and poor contact

The Exit 2 Motor for revolution failure:

Component Control

The Exit Gate Solenoid for failure:

Component Control

(GP

16). If no problems are found, replace the MCU PWB

WorkCentre 5335 Family Service Documentation

[077-100]

(PL

17.4)

P/J115

and the MCU PWB

P/J411

for open

[077-015]

(PL

17.5)

[077-004]

(PL

17.4)

(PL

Initial Issue