Коды неисправностей:
093-926 — ошибка черного (K) картриджа
093-960 — ошибка желтого (Y) картриджа
093-961 — ошибка красного (M) картриджа
093-962 — ошибка синего (C) картриджа
Решение:
— Убедитесь, что картридж установлен в свою позицию.
— Убедитесь, что картридж правильный (не от другого аппарата).
— Убедитесь, что картридж надежно зафиксирован.
— Убедитесь, что дверца закрыта.
— Замените неисправный картридж.
— Замените дверцу тонерного отсека.
— Если действия, перечисленные выше, не помогли — замените плату MCU PWB.
-
10-23-2017
#1
Senior Tech
250+ Posts
- Rep Power
- 0
Xerox workcentre 6015 error 093-926
Hello display says 093-926 what does mean it?I changed black toner. What can I do to solve it? Thanks
-
10-24-2017
#2
Senior Tech
100+ Posts
- Rep Power
- 32
Re: Xerox workcentre 6015 error 093-926
was there any other work you did on this machine? this error refers to NVM settings on the MCU board.
try this
1. Power on the printer while pressing the Up and Down Arrow keys.
2. Press the Up or Down Arrow key to select Printer, and then press the OK key. 3. Press the Up or Down Arrow key to select IOT Diag, and then press the OK key. 4. Press the Up or Down Arrow key to select NVM Settings, and then press the OK key 5. Press the Up or Down Arrow key to select LoadNVM from ESS, and then press the OK key. 6. Press the OK key twice to execute LoadNVM from ESS.
-
06-02-2021
#3
Junior Member
- Rep Power
- 0
Re: Xerox workcentre 6015 error 093-926
work all operations but et the end eror is there
01.06.2013
Вопрос:
Первый раз заменили в Xerox 5225 тонер-картридж на новый, а drum не менял, аппарат просит переустановить неверно установленный заменяемый узел…………………. и выдает ошибку 093-926.
Ответ:
Уточните номер заменяемого тонера возможно он от другой модели!
Задайте свой вопрос
Чтобы задать вопрос, Вам необходимо авторизоваться
•
The connection terminals between the Toner Cartridge CRUM PWB and the Toner
CRUM PWB for damage and foreign substances
•
The Toner Cartridge for improper installation
If no problems are found, replace the following parts in sequence:
•
Toner Cartridge (K)
(PL
8.1)
•
Toner CRUM PWB
(PL
8.2)
•
MCU PWB
(PL
18.2)
Status Indicator RAPs
093-925, 093-926
BSD-ON:
BSD 9.1 — CRU Life Control
Incorrect authentication area data was detected in the Toner CRUM. This fault is displayed if
the wrong type of Toner cartridge is installed.
NOTE: The WC 5325/5330/5335 is shipped with «Worldwide Neutral» Toner Cartridges. When
the cartridges shipped with the machine are installed, the machine is set to Worldwide Neutral
configuration.
When the first toner cartridge is replaced in the WC 5325/5330/5335, the Geographic Differen-
tiation Code and Toner Cartridge Type in NVM are automatically changed to the same settings
as the replacement cartridge. Once these NVM are set, the WC 5325/5330/5335 toner config-
uration can only be changed with a CRUM conversion.
One or more Toner Cartridges are of the wrong type (i.e., a «Sold» cartridge installed in a
«metered» configured machine.
Initial Actions
Remove and reinstall the Toner Cartridge.
Procedure
An Error Message appears on the UI — Reinsert an improperly seated consumable or
replace any consumable with an Error. Press Machine Status button and select Supplies
tab for details. Remove and reinstall the Toner Cartridge and check for improper installation.
The problem continues
Y
N
End
Check the NVM locations in
NVM Location
767-094
767-104
The NVM values match the expected customer configuration.
Y
N
Determine correct Contract Type from customer. Contact Technical Support Center or
your NTS for the CRUM conversion procedure.
1.
Polish the connection terminals between the Toner Cartridge CRUM PWB and the Toner
CRUM PWB with a dry cloth. (When cleaning, do not use Drum cleaner, etc.)
2.
Check the following:
•
The connection between the MCU PWB
for open circuit, short circuit, and poor contact
07/2011
2-836
BUS Updated 12/2011
Table
1.
Table 1 CRUM Data NVM
Name
Values (read-only)
Geographic Setting
3 = North America/Europe
12 = DMO
15 = Worldwide
Contract Type
2 = Sold
3 = Metered
31 = Neutral
P/J404
and the Toner CRUM PWB
WorkCentre 5335 Family Service Documentation
P/J102
Initial Issue